How to Dose Ariel Liquid Detergent?

Using the right amount of detergent can make everyday laundry much easier. If you want to know how to dose Ariel liquid, consider how many clothes you are washing, how dirty they are and whether your home has hard or soft water.  

This approach helps clean everyday family laundry, including school uniforms and cotton clothes, as well as delicate abaya fabrics, while using the right amount of detergent for effective cleaning. 

Key Highlights

  • Match the Ariel liquid detergent dose to the size of your laundry load, the level of soiling and your water hardness. 

  • For Ariel Platinum Clean Gel, use one full scoop (100 ml) for one load, following the dosing instructions on the product pack. 

  • Measure the detergent with the recommended scoop or dosing cap rather than pouring it directly from the bottle. 

  • Add Ariel Platinum Clean Gel to the main-wash compartment, or use the dosing cap in the drum if the product instructions allow it. 

  • Choose a wash programme and water temperature that are suitable for the fabrics and garment care labels. 

Why Does the Correct Dose Matter?

Too little detergent may not remove sweat, dust, body oils or food marks properly. Too much can create excess foam or leave residue on clothes and inside the washing machine. The correct dose provides enough cleaning power while allowing the detergent to rinse away. 

What Determines the Right Dose?

No single amount suits every wash. Check these three factors before measuring your detergent. 

1. Load size

A small load needs less detergent than a full load. Look at the amount of dry laundry rather than simply counting garments. A few lightweight shirts are different from a load of towels or thick cotton clothes. Do not pack items tightly into the drum. Place your palm above the laundry. If your hand does not fit, remove a few items. Clothes need space to move so water and detergent can reach them evenly. 

2. Dirt Level 

Lightly soiled clothes generally need less detergent than heavily soiled items. Check collars, cuffs and underarm areas before washing. Clothing exposed to sweat, outdoor dust, cooking oil or food spills may need a higher dose when the dosing guide recommends it. Separate heavily soiled items from lightly worn clothing when possible. This makes it easier to choose a suitable dose for each load. 

3. Water Hardness 

Hard water contains dissolved minerals that can reduce detergent performance. Water conditions vary between locations and buildings. Limescale around taps or mineral deposits in the washer may indicate hard water. Use the water-hardness level in the dosing table when available. If you are unsure, ask your water supplier or building management.

How to Measure and Add Ariel Liquid Detergent 

Follow these simple steps: 

  1. Sort the clothes. Separate whites from colours and group similar fabrics. Check pockets and care labels. 

  2. Assess the load. Decide whether it is small, regular or large. Check whether the clothes are lightly, normally or heavily soiled. 

  3. Measure the detergent. Check the recommended dose on the package. For Ariel Platinum Clean Gel, the recommended dosage is one full scoop for one load (100ml). 

  4. Add it correctly. Pour the measured liquid into the main-wash compartment. If your product allows a filled dosing cap in the drum, place it as directed. Never put detergent into the fabric-softener compartment. 

  5. Choose the programme. Match the cycle and water temperature to the garment care labels. 

  6. Start the wash. Remove clothes soon after the cycle finishes and dry them completely. 

How to Pre-Treat a Stain

Start by checking the garment’s care label, then apply a small amount of Ariel Platinum Clean Gel to the stain and gently spread it. Avoid rubbing the fabric too harshly, as this may push the stain deeper into the fibres or cause it to spread.  Wash the garment before the detergent dries, paying particular attention to areas that commonly collect collar, cuff, sweat and food marks. Once the wash cycle is complete, check that the stain has been removed before putting the garment in the dryer, as heat can make some stains more difficult to remove. 

Common Dosing Mistakes

Avoid these simple mistakes: 

  • Pouring detergent without measuring 

  • Adding extra liquid to an overloaded drum 

  • Using the same amount for every load 

  • Ignoring water hardness and dirt levels 

  • Placing liquid in the wrong drawer compartment 

  • Assuming different detergent formats use identical measures 

Store Detergent Safely

Always close the detergent bottle tightly and place it upright in a cool, shaded and dry storage area. Keep it away from children and pets. For safety, leave the detergent in its original container with the label clearly visible. 

Ariel logo

FAQs

Ariel logo
  • Add Ariel Platinum Clean Gel to the main-wash compartment of your washing machine, using the recommended amount for your load. If the product instructions allow drum dosing with the cap, you can measure the gel in the cap and place it directly in the drum before adding your clothes.

  • Yes, Ariel Platinum Clean Gel can be used in both front-load and top-load washing machines. The amount will depend on the wash volume and how dirty the clothes are and the hardness of your water.

  • Yes, Ariel Platinum Clean Gel is suitable for small loads as well as for heavily soiled clothes.

  • Ariel Platinum Clean Gel is designed for effective everyday cleaning and also helps care for your clothes. Always use the right dose and select a wash programme suited to the fabric.

  • Yes, Ariel Platinum Clean Gel makes everyday laundry convenient because it is easy to measure and use.